Style Guide April 2023 Full

CONFIGURATIONS The following illustrations demonstrate some of the more common configurations using the components previously listed. NOTE: FOR SPOT LIGHTING THE TOTAL WATTAGE REQUIREMENTS AND NUMBER OF PORTS ARE THE MOST IMPORTANT FACTORS TO BE TAKEN INTO CONSIDERATION WHEN IDENTIFYING WHICH DRIVER(S) WILL BE REQUIRED FOR THE CUSTOMER DURING THE DESIGN PROCESS - A PORT EXPANDER / EXTRA DRIVER MAY BE REQUIRED.

Standard Under Cabinet LED Installation

TLED1, 2, 3. 2w - up to 15 units.

Wall Switch

TLEDPEXP

TCONV14

Optional

Mains Power

24v / 30w Driver

Port Expander

The 30w driver is capable of running 15 x 2w LEDs. It has 6 outputs. If the requirement is for more LED units the optional port expander will add another 12 outputs allowing the connection of more LEDs up to the maximum rated wattage for the driver.

Domestic Wall Dimmer Under Cabinet LED Installation

A wall mounted dimmer should be supplied and fitted by the customer. The kitchen fitter will connect to the output of the dimmer switch.

Mains Power

TLED1, 2, 3. 2w - up to 15 units.

TLEDPEXP

TDIMCONV2

Optional

Wall Dimmer

24v / 30w Dimmable Driver

Port Expander

Under Cabinet LED Installation using a Remote Handset

TLED1, 2, 3. 2w - up to 15 units.

TLEDPEXP

The single colour receiver and remote will control the ON/OFF function and the dimming of the compatible connected units.

Optional

TSMARTREC2 SINGLE COLOUR RECEIVER

TCONV14

Port Expander

Mains Power

Up to 30m range depending on conditions.

24v / 30w Driver

TREMOTE1

Under Cabinet LED Installation with IR Sensor

TLED1, 2, 3. 2w - up to 15 units.

TLEDPEXP

TCONV14

Optional

Mains Power

24v / 30w Driver

TSENSOR5

Port Expander

The IR sensor will allow close proximity activation and can be surface mounted or used with the included bracket. It can be door activated or hand activated. When set as hand activated it can also be used to dim the LED units.

IR Sensor

5